Municipal package surface modular water treatment systems

Integrated fully automatic water purification equipment purification process

1. Coagulant dosage:

According to the turbidity of the raw water, use a dosing device to evenly mix the coagulant into the pipeline mixer.

2. Coagulation and sedimentation:

Suspended solids and colloidal particles in water generate coarse alum flowers for automatic precipitation, achieving solid-liquid separation, reducing the burden of filtration, and saving backwash water consumption.

3. Filtering:

The residual small alum flowers are intercepted by the filter layer, resulting in a turbidity of 0.4~1 NTU in the effluent;

The filter layer is composed of 4-7 different media filter media, which can trap solid particles in the filter layer and achieve a cleaning rate of over 98%.

4. Disinfection:

After being disinfected by an electrolytic sodium hypochlorite generator, it flows into a clean water tank.

5. Automatic backwashing:

The increase in the interception capacity of the filter layer causes the water level to rise. When the design requirements are met, a bottom-up backwash is carried out, and the filtration is automatically restored after the flushing is completed.

The backwash water is provided by the filter water tank, with a backwash strength of 8-66l/s · m ², The recoil takes 3-6 minutes.

Main technical parameters of the equipment

Integrated fully automatic water purification equipment

Raw water turbidity: ≤ 1500 mg/L, short-term up to 3000 mg/L

Turbidity of effluent: ≤ 1NTU (in special cases ≤ 3NTU)

Reaction time: 10-20 minutes

Steady flow zone flow rate: 1.8-2.7 millimeters/second

Rinsing intensity: 14-16 liters/square meter • second

Rinsing time: 2-8 minutes

Inlet water head: ≥ 8 meters